Assembly - Macros
Writing a macro is another way of ensuring modular programming in assembly language.
A macro is a sequence of instructions, assigned by a name and could be used anywhere in the program.
In NASM, macros are defined with %macro and %endmacro directives.
The macro begins with the %macro directive and ends with the %endmacro directive.
The Syntax for macro definition âˆ’
%macro macro_name number_of_params <macro body> %endmacro
Where, number_of_params specifies the number parameters, macro_name specifies the name of the macro.
The macro is invoked by using the macro name along with the necessary parameters. When you need to use some sequence of instructions many times in a program, you can put those instructions in a macro and use it instead of writing the instructions all the time.
For example, a very common need for programs is to write a string of characters in the screen. For displaying a string of characters, you need the following sequence of instructions âˆ’
mov edx,len ;message length mov ecx,msg ;message to write mov ebx,1 ;file descriptor (stdout) mov eax,4 ;system call number (sys_write) int 0x80 ;call kernel
In the above example of displaying a character string, the registers EAX, EBX, ECX and EDX have been used by the INT 80H function call. So, each time you need to display on screen, you need to save these registers on the stack, invoke INT 80H and then restore the original value of the registers from the stack. So, it could be useful to write two macros for saving and restoring data.
We have observed that, some instructions like IMUL, IDIV, INT, etc., need some of the information to be stored in some particular registers and even return values in some specific register(s). If the program was already using those registers for keeping important data, then the existing data from these registers should be saved in the stack and restored after the instruction is executed.
Following example shows defining and using macros âˆ’
; A macro with two parameters ; Implements the write system call %macro write_string 2 mov eax, 4 mov ebx, 1 mov ecx, %1 mov edx, %2 int 80h %endmacro section .text global _start ;must be declared for using gcc _start: ;tell linker entry point write_string msg1, len1 write_string msg2, len2 write_string msg3, len3 mov eax,1 ;system call number (sys_exit) int 0x80 ;call kernel section .data msg1 db 'Hello, programmers!',0xA,0xD len1 equ $ - msg1 msg2 db 'Welcome to the world of,', 0xA,0xD len2 equ $- msg2 msg3 db 'Linux assembly programming! ' len3 equ $- msg3
When the above code is compiled and executed, it produces the following result âˆ’
Hello, programmers! Welcome to the world of, Linux assembly programming!